Help with shock intstall
#1
Join Date: Feb 2006
Location: Dyersburg, TN
Posts: 524
Likes: 0
Received 0 Likes
on
0 Posts
#5
pull the metal piece out......lube the inside of the rubber bushing and the metal piece with soap.....start the metal piece in the bushing.......put it on a hard surface and push in with the shock.....
^^that is what i did to my mom's Explorer's shocks when i replaced them last winter....
^^that is what i did to my mom's Explorer's shocks when i replaced them last winter....
#9
Join Date: Feb 2006
Location: Dyersburg, TN
Posts: 524
Likes: 0
Received 0 Likes
on
0 Posts
#11
Join Date: Feb 2006
Location: Dyersburg, TN
Posts: 524
Likes: 0
Received 0 Likes
on
0 Posts
#13
#15
i remember now!
i know u have been PMing me but oh well.
the slop is fine that is how mine are and they are fine. its such a small amount it wont matter.
as for the wide bushing what i did was ground some off the metal tube piece then i spread the mount on the axle some. slide it in and bolted it up
i know u have been PMing me but oh well.
the slop is fine that is how mine are and they are fine. its such a small amount it wont matter.
as for the wide bushing what i did was ground some off the metal tube piece then i spread the mount on the axle some. slide it in and bolted it up
Thread
Thread Starter
Forum
Replies
Last Post
stvndew
General Ford Ranger Discussion
12
03-12-2012 01:46 PM
sem1845
General Ford Ranger Discussion
19
02-16-2007 10:06 AM