Please Help. Ride Height!
#1
Please Help. Ride Height!
Alright, I am stuck... Here is the back story.
2005 Ford Ranger XLT. Did the DJM 4/5 drop. Surprisingly smooth install. Broke one bolt and was my own fault (over torqued). I have an odd Ranger Lean going on. Truck leans to the passenger side; front and rear. It does not lean much but I am a perfectionist.
Front of the truck leans about .5" to the passenger side and the rear leans about .5-1" to the passenger side. I have pulled this apart and nothing seems out of place. I have heard of Rangers leaning towards the driver side, and only a few post for passenger side lean. Could my leafs be bad? Any input would be great.
Pics below
Thanks Gents.
2005 Ford Ranger XLT. Did the DJM 4/5 drop. Surprisingly smooth install. Broke one bolt and was my own fault (over torqued). I have an odd Ranger Lean going on. Truck leans to the passenger side; front and rear. It does not lean much but I am a perfectionist.
Front of the truck leans about .5" to the passenger side and the rear leans about .5-1" to the passenger side. I have pulled this apart and nothing seems out of place. I have heard of Rangers leaning towards the driver side, and only a few post for passenger side lean. Could my leafs be bad? Any input would be great.
Pics below
Thanks Gents.
#2
Alright, little update. Put the truck in the shop again. Looked over everything. Leafs look good. mounts, bushings, shackles etc... I was thinking if I were to cut about 1/2 a coil on the driver side it would lower that and in turn bring up the back passenger side. Any input.
Thanks again.
Thanks again.
#5
#6
#7
#9
Thread
Thread Starter
Forum
Replies
Last Post