Shock bolt
#2
RF Veteran
iTrader: (1)
#3
#4
I used a 5/8" x 4" grade 8 bolt cut down to size and welded it where the old stud was after cutting the old stud off and smoothing it out. Works better than the original and I may do the same to the other side just to make it better also. Really simple repair and it took approx. 30 minutes to complete. Don't forget to paint the new stud to prevent it from rusting and don't forget to use loctite on the grade 8 nut. I also used a 2" zinc plated fender washer in front of the nut to keep the shock on the new stud.
The following users liked this post:
EdsRanger93 (04-17-2020)
Thread
Thread Starter
Forum
Replies
Last Post