Steering stabilizer install problem
So I ordered a Skyjacker steering stabilizer kit for my 92 Ranger with a 4" lift. This kit has a solid mounting point on the frame on the passenger side right near the sway bar bracket. I got all the brackets installed but the threaded part of the shock is so close to the sway bar that I cannot get the bushing on. The instruction manual showed a picture of a Ranger or Exploder without a sway bar. Question is, should I remove the sway bar?
Edit: I did some reading about removing the sway bar. I have stiffer front shocks and my front end hardly articulates when I go off roading...which sucks because there are a lot of times where I feel like I am going to tip over as the front doesn't flex but the rear is coming off the ground because of it. I drive 75 miles a day to work, which about 15 miles of that is backroads and the rest all highway. Just trying to get some insight if anyone ran into this issues before.
Last edited by russiankid; 06-21-2011 at 10:23 PM.