Just ordered superlift
#1
Just ordered superlift
I just ordered superlift. I've been going through the forums and for what I've seen people are saying it's pretty easy to do. Some people were saying it was easier than a BL. I'm just wondering is there anything I should be prepared for as far as installing the lift? It's going on a 07 Ranger Sport.
#2
I just ordered superlift. I've been going through the forums and for what I've seen people are saying it's pretty easy to do. Some people were saying it was easier than a BL. I'm just wondering is there anything I should be prepared for as far as installing the lift? It's going on a 07 Ranger Sport.
Don't know if it causes an issue with the supercity shafts since I still haven't gotten one.
#3
OP: Just take your time and follow the installation guide. A torch and an impact will make your life a lot easier. (I still ended up cutting my LCA bolts).
#4
I can just throw some heat to it and bend it that way right? And how long has your stock drive shaft lasted? I didn't get the custom superlift one cause I was just gonna ride my stock one for a bit.
#6
Torch was for heating up bolts. My truck has spent it's whole life in the rust belt, so some of the bolts were a little stubborn.
I ran my stock drive shaft for 1,000 miles or so. I could've gotten more out of it, but I had the new made up anyway. I was afraid of the stock one taking a **** on me at an inconvenient time. Haha
I ran my stock drive shaft for 1,000 miles or so. I could've gotten more out of it, but I had the new made up anyway. I was afraid of the stock one taking a **** on me at an inconvenient time. Haha
#7
#8
Good deal. Some of the bolts may have factory lock tite on them as well (heat will come in handy for those)
Yea, it's kind of a crap shoot as to how long the stock one will last. I would get a new one built/buy the super lift one as soon as time and money allow. In the mean time you can just carry an 8mm wrench/t25(?) bit/ratchet around with you. That way if the drive shaft does **** the bed, you can just pull it and be on your way.
#9
#10
#11
#14
#15
Thread
Thread Starter
Forum
Replies
Last Post
Pinecone
General Ford Ranger Discussion
23
03-17-2005 03:31 AM
Wowak
Wheels & Tires Semi-Tech
8
08-15-2004 10:33 PM
rangerkev
Ranger Products, Company, & Member Reviews
2
07-08-2004 02:00 PM
ravensedge
Exterior Semi-Tech
10
06-21-2004 02:09 PM