will the FX4 II alcoa rims fit other rangers (like my non- level II). at a glance, there isn't much room to fit a smaller rim.

do the FX4 IIs use a smaller rotor? caliper?

i'd like to put on the alcoas but there's no point if they don't fit...

 

Rotor and caliper is the same 12" on all 4x4s from 2003 1/2 and up. The 15" LII Alcoas will fit your 06 FX4.

 

the FX4 Level II Alcoa's will fit ANY Ranger.....even an '83.......the Level II's don't have any different size rotor than any other Ranger....

 

i didn't think they'd do anything that dumb like downsize rotors to get on a 15" wheel , but i didn't want to find out the hard way... anyhow, unless i find the alcoa/BFG combo cheap, i'll go to the aftermarked. i'm thinking 17" procomp rims, and maybe Cooper STTs... http://www.procomptires.com/pxa7005.html

 

there isnt much room with a 15" wheel

but they fit

 

they wont fit an edge though due to the spindle snout, better explained- they fit fine but you just cant use the centercaps.

i had that problem when i got my lvl2 and was getting ready to sell the trailhead, i wanted to pull the beadlocks off my trailhead and swap them with the lvl2 wheels but they fit like hell so i abandoned it.

 

(for future searches)

I can confirm this. I have the alcoa's on my Edge but cannot use the centercaps up front.

 

UH.....wrong.

 

Your proof being..?

 

I believe that he is referring to the 2WD EDGE. You guys need to be specific, they made the Ranger edge with more than one drive line....

Personally I don't see why they wouldn't fit, but since I don't have em, I guess I can't say for sure....

 

yes, i was referring to the 2wd. they bolt up fine, like any ranger 5 on a 4.5 wheel, your front center caps just wont fit right. you have to take a dremel tool and grind it out. That is if you want to use your center caps.


fx4wannabe, try it and you will see for yourself.

 

I am sure FX4wannabe was referring to the 4x4 version, thats why I said be specific....lol

 

BZZZZZZZZZZZZZ WRONG.... all you need to do is this...



thats how i got mine to work...

 

read above, thats why i said dremel tool.

i did that to mine also to get them to work

 

duders....those danged torsion bars on a 2wd throw me the hell off. My Bad. Maybe it's similar to the mustang cobra rims...trying to fit them on a 2wd coil sprung ranger. Run a 7/16" spacer with longer studs to solve the problem. The disc "hub" is too large to fit the wheel hub opening aka " that hole in the center". I totally understand now. duders, no disrespect here.

 

haha, its cool