Any ideas on a color matched ring
#1
#2
Older F-150's had chromed or stainless or something and they had 15" rims. Go to a junkyard, get a set in reasonable condition.
Then steel wool the living crap out of them, clean them with solvent and handle them with clean gloves. Spray them with a few light coats of primer from a rattle can, building it up slowly to cover.
If you use a "sandable" primer you can use some extra-fine sandpaper to smooth them out. Then use what's called a "tack cloth" to clean off the dust.
Then hit them with a spray close to your body color. Should be easy and cheap and you can probably get a set of the rings from the JY for $20 or less. Maybe another $20 to $30 for paint and stuff. Should be a cheap mod.
Then steel wool the living crap out of them, clean them with solvent and handle them with clean gloves. Spray them with a few light coats of primer from a rattle can, building it up slowly to cover.
If you use a "sandable" primer you can use some extra-fine sandpaper to smooth them out. Then use what's called a "tack cloth" to clean off the dust.
Then hit them with a spray close to your body color. Should be easy and cheap and you can probably get a set of the rings from the JY for $20 or less. Maybe another $20 to $30 for paint and stuff. Should be a cheap mod.
Thread
Thread Starter
Forum
Replies
Last Post
Scallion02EDGE
Interior, Exterior, & Electrical
6
11-20-2011 09:28 PM
Lumadar
General Ford Ranger Discussion
14
09-08-2005 06:14 PM
Strider0O0
Interior, Exterior, & Electrical
7
02-21-2005 05:42 PM