body lift and stock skid plate??
 

So how does the stock front engine skid plate look with a body lift? Any pics?

i wouldnt have a body lift and not have a skid plate, it will look very bad!

heres mine

Attachment 202432

There is a current thread going on right now that discusses that exact same question.....and has two pics. I'll see if i can find it for ya.

Found it....

https://www.ranger-forums.com/forum2...ad.php?t=60988

I know these bumpers are don't hang down as low as the 01+ style, but you get the picture....

Attachment 202431

http://a480.ac-images.myspacecdn.com...79c88e0e37.jpg

so what your saying is with a 02 edge i shouldnt have a gap between the bumper valence and the skid plate?

You should be ok, there is a few inches between the skid plate lip and the bottom of the valance at stock height.

Ya i must say I was pissed when I did mine and I had that gap. I am seriously conisdering a 01-03 bumper/valance swap. With the new bumper you are fine..I covered up mine best I could be I aint feelin that gap!