Exhaust parts... are these the right ones?
#1
Exhaust parts... are these the right ones?
Ok Im going to get my exhaust done before I do the new tires and rims.
I was wondering what the size of the pipes coming out from the flange after the cat was?
I found this on advanced auto parts's site and Im gonna but it and bring it to the exhaust place so they have to do less bending and welding... which one do I need?
http://www.partsamerica.com/ProductD...pe=688&ptset=A
http://www.partsamerica.com/ProductD...pe=688&ptset=A
And if I buy a muffler that is 2.25 inch can the shop use a pipe expander to make the muffler fit on the pipe? I dont know wat size out pipe is so any help would be greatly appreciated.
heres the muffler I am going with:
http://store.summitracing.com/partde...5&autoview=sku
I was wondering what the size of the pipes coming out from the flange after the cat was?
I found this on advanced auto parts's site and Im gonna but it and bring it to the exhaust place so they have to do less bending and welding... which one do I need?
http://www.partsamerica.com/ProductD...pe=688&ptset=A
http://www.partsamerica.com/ProductD...pe=688&ptset=A
And if I buy a muffler that is 2.25 inch can the shop use a pipe expander to make the muffler fit on the pipe? I dont know wat size out pipe is so any help would be greatly appreciated.
heres the muffler I am going with:
http://store.summitracing.com/partde...5&autoview=sku
#2
#3
i had something done with my exhaust, since the flowmaster 40 series had a 3inch inlet, i kept my stock 2'' pipe but towards the muffler the inlet part, they fabricated a 3 inch piece of pipe on the end of the 2'' pipe. not sure if thats how everyone is done but i know i probably didnt lose any backpressure, i too went with the 2.25'' with the duals out the back.
#4
Originally Posted by Ranger Kid17
i had something done with my exhaust, since the flowmaster 40 series had a 3inch inlet, i kept my stock 2'' pipe but towards the muffler the inlet part, they fabricated a 3 inch piece of pipe on the end of the 2'' pipe. not sure if thats how everyone is done but i know i probably didnt lose any backpressure, i too went with the 2.25'' with the duals out the back.
#5
Thread
Thread Starter
Forum
Replies
Last Post
LeesonHE
General Technical & Electrical
2
07-13-2013 10:58 PM
dixie_boysles
General Ford Ranger Discussion
16
06-24-2009 11:26 AM