1999 Ranger loses all power when turning key to start
#1
1999 Ranger loses all power when turning key to start
hey i have a issue that im not sure what it is.. i have a 1999 ranger 4x4 3.0l and yesterday it started just fine the first 4 times i started it but then suddenly i stop for gas and came back out and went to start it but as soon as i turned the ignition to start it just clicked once and all power was gone then nothing when i tried turning the key over. but i take the negative cable off the battery and mes with it for a sec and put it back on and all power is just fine again but does the same thing when i try to start it. happens over and over. i changed the oil a couple days prior and as stupid as it is the ooil filter is directly above the start and oil got all over it so i put in a new starter today and still same thing. my battery is good full charge. i would assume its a ground issue but figured id get more opinions on the issue. any ideas? thanks
#3
the ground is what everyone says it is and first thing i figure it was also but i installed all new cables for ground and power and still have the issue. i even put a new starter in cause the one that was in it was covered in oil. how is the grounding suppose to be setup in this truck? battery - to chassis, chassis to engine... are there more connections for the ground?
#5
Thread
Thread Starter
Forum
Replies
Last Post
fabioonachopper
DOHC - 2.3L Duratec / Mazda L Engines
3
04-23-2010 08:20 AM