New guy at a loss with my 3.0 not starting
#1
New guy at a loss with my 3.0 not starting
I did a full tune up on my truck recently and now my truck wont start. Its a 93 3.0 2wd ranger with a 5 speed. I did cap, rotor, plugs, wires, and a fuel filter and the truck wouldnt start afterwards. Fuel wasnt strong at the schraeder valve so i pulled the bed and did a new fuel pump and filler neck while i was at it. Now the fuel pressure is in spec, i have spark, inertia switch isnt tripped. The truck will crank but not start. Idk whats going on here and i need my truck back asap. Air filter and maf sensor are new and clean. Any ideas guys ? The truck was slightly stumbling under acceleration in certain rpms and load, hence my reason for the tune up, which it desperately needed. Any clues fellas ? Thanks for any help
Thread
Thread Starter
Forum
Replies
Last Post
smokindmax
SOHC - 2.3L & 2.5L Lima Engines
5
09-01-2009 10:33 AM
monarchdad
General Technical & Electrical
3
02-24-2007 10:33 PM