2.9L & 3.0L V6 Tech General discussion of 2.9L and 3.0L V6 Ford Ranger engines.

hesitates in 1st gear

Thread Tools
 
Search this Thread
 
  #1  
Old 01-30-2011
mrbien2080's Avatar
Member
Thread Starter
Join Date: Jan 2011
Location: albuquerque new mexico
Posts: 18
Likes: 0
Received 0 Likes on 0 Posts
hesitates in 1st gear

01 ranger edge 2wd V6 3.0, hesitates in first gear when i take off. I am going change oil, plugs, plug wires and air filter. But was curious if i should check my fuel injectors as well, if so how hard are they to get to and how can i check to see if they are bad??
 
  #2  
Old 01-30-2011
STUPIDHEAD11's Avatar
Member
Join Date: Oct 2010
Location: Melbourne, Florida
Posts: 219
Likes: 0
Received 0 Likes on 0 Posts
Injectors are not easy to get to on the passenger side and IMO that is completely useless. On modern vehicles injector rarely go bad. Does it hesitate in only first? or all gears but first is most prominent? Most problems with ranger hesitation out of idle and first gear are due to gas problems (filter, pump, etc.) or air intake (MAF, throttle body, etc). I wouldnt play with your injectors, never known anyone that has needed too
 
  #3  
Old 01-30-2011
mrbien2080's Avatar
Member
Thread Starter
Join Date: Jan 2011
Location: albuquerque new mexico
Posts: 18
Likes: 0
Received 0 Likes on 0 Posts
Just first gear, well ill start with spark plugs, wires and air filter then see where im at. How hard is it to replace fuel filter, ifits easy maybe ill just do that too
 
  #4  
Old 01-31-2011
SkidPlate's Avatar
Member
Join Date: Sep 2010
Location: La Crete , Alberta
Posts: 43
Likes: 0
Received 0 Likes on 0 Posts
I wish people would describe their problem a lot better. Hesitates doesn't tell much about what the truck is actually doing. Does it only happen in first gear from a stop or while your rolling and kick it in the ***. does it happen when it's cold when it's hot. does it have a lack of power when you go to pass someone. Is it automatic or manual? What kind of mileage?

The better the description of your problem the easier it is to help you narrow down or even zero in on what is causing it. Every detail helps even things that might seem irrelevant.

Go ahead and do the plugs, wires, a/f, f/f and oil change. Sometimes a little maintenance will do wonders.
 
  #5  
Old 01-31-2011
STUPIDHEAD11's Avatar
Member
Join Date: Oct 2010
Location: Melbourne, Florida
Posts: 219
Likes: 0
Received 0 Likes on 0 Posts
^ if that aint the truth idk what is. Your fuel filter is real easy to do. Ive got a 2000 ranger same motor and your filter is on the inside of your driver side "fuel rail" or the driver length of the frame. You can google pics. The part is relatively cheap. But like Scot said: just simple maintenance...a good solid 1+ hour oil change (the last few drops are the worst), changing to a good purolator or decent brand air filter, getting a new set of plugs (wouldnt do the coil or wires...the stocks rarely go bad except after wrecks), heck even sea foaming (I recommend) all of this will positively affect your vehicle in ways you wouldnt realize. maybe even a tranny fluid change. or rear diff change as well. idk your money situation but a front to back fluid change is great
 
  #6  
Old 01-31-2011
StxDangerRanger's Avatar
RF Veteran
iTrader: (2)
Join Date: Dec 2010
Location: Michigan
Posts: 6,315
Likes: 0
Received 6 Likes on 6 Posts
just keep up on the maintenance of your truck do the correct changes at the correct milage and things should be fine. i've got a 94 4.0 that only has a lifter tick. and i do everything within a 1000 miles or so of what the owners manual recommends. every once in a while throw some Fuel injector/system cleaner in your tank with some 93 octane and seafoam your engine every once in while about 50 or 60 miles before you change the oil and plugs and you'll be good to go.
 
  #7  
Old 01-31-2011
mrbien2080's Avatar
Member
Thread Starter
Join Date: Jan 2011
Location: albuquerque new mexico
Posts: 18
Likes: 0
Received 0 Likes on 0 Posts
I changed the spark plugs, wires and changed the oil and the air filter, def running better. I guess it was just lacking some maintenance, i guess i need to start being a better owner lol. But thanks for the help guys..
 
  #8  
Old 01-31-2011
SkidPlate's Avatar
Member
Join Date: Sep 2010
Location: La Crete , Alberta
Posts: 43
Likes: 0
Received 0 Likes on 0 Posts
Change the fuel filter too. glad to see it was just lack of maintenance.
 
  #9  
Old 01-31-2011
Taylor's Avatar
Ive been dubbed....an old volk
iTrader: (18)
Join Date: Mar 2010
Location: Nashville, NC
Posts: 7,110
Likes: 0
Received 3 Likes on 3 Posts
Keep the maintenance up, and if ever in doubt.....the skinny pedal...more of it.
 
  #10  
Old 01-31-2011
STUPIDHEAD11's Avatar
Member
Join Date: Oct 2010
Location: Melbourne, Florida
Posts: 219
Likes: 0
Received 0 Likes on 0 Posts
^ gosh this thread is full of honesty.

two rules so far:
1. keep good care of your truck internally as well as externally
2. The better pedal is the smaller one to hit...i like to think of it as heaven...few find the small pedal but many find the big pedal...
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
ryguy
Drivetrain Tech
4
07-01-2013 03:04 PM
Bird76Mojo
eBay & Craigslist Finds
0
12-15-2010 03:25 PM
99ranger4x4
4.0L OHV & SOHC V6 Tech
12
11-13-2006 11:53 AM
moenko
SOHC - 2.3L & 2.5L Lima Engines
6
08-08-2006 07:13 AM



Quick Reply: hesitates in 1st gear



All times are GMT -6. The time now is 08:20 PM.