2.9L & 3.0L V6 Tech General discussion of 2.9L and 3.0L V6 Ford Ranger engines.

Frustrated with Truck

Thread Tools
 
Search this Thread
 
  #1  
Old 02-21-2014
rangerxl94's Avatar
Member
Thread Starter
Join Date: Feb 2014
Location: port angeles
Posts: 13
Likes: 0
Received 0 Likes on 0 Posts
Frustrated with Truck

Hello all hoping for some insight i just replaced the lower radiator hose today that was fun. I drove it all around and noted no issues didnt get hot or anything took it to parent in laws father in law said he smelt coolant leaking again checked it didnt see anything got it home into a better light and it looks like it might be slowly leaking from transmission cooler line on the top and possibly the right side of the radiator.

Question is do need to now replace the radiator too?

Truck has been sitting for two years before i got it, how easy is the radiator to replace on the 94 ranger 3.0 v6?
 
  #2  
Old 02-21-2014
pearlkid9988's Avatar
Member
Join Date: Dec 2008
Location: Newnan Georgia
Posts: 828
Likes: 0
Received 2 Likes on 2 Posts
Radiator is easy to replace but if its coming from the cooler line do it quick that means the tanks are rusted through you DONT want coolant in your trans fluid it will cause major damage. Id also recommend a trans flush after to to make sure theres none in there.
 
  #3  
Old 02-21-2014
RonD's Avatar
RF Veteran
iTrader: (1)
Join Date: Jan 2014
Location: Vancouver, BC
Posts: 30,654
Received 2,820 Likes on 2,586 Posts
I would first confirm where the leak is.

Warm engine up so the coolant in the rad is under pressure, then shut off engine.
Remove the two bolts on the top of the fan shroud, lift it slightly so tabs at bottom come out, then move shroud backwards.
This should give you a better view of lower rad.
Take a towel and wipe the area you think is leaking, then watch where coolant seeps out.

If it is the rad leaking then at this point you would drain coolant.
Remove upper and lower rad hoses from rad.
Remove trans cooler lines, these WILL leak trans fluid, so cap them with plastic baggies held tight by rubber band or ??
The cooler itself will leak out fluid so ...........if you can plug the holes great, if not have a bucket or towels handy.

The rad is held in place by two bolts, one on each side of upper rad, bottom of rad has two pegs that slide down into rubber grommets, so once the two bolts are removed rad will just lift up and out.
 

Last edited by RonD; 02-21-2014 at 08:47 AM.
  #4  
Old 02-21-2014
rangerxl94's Avatar
Member
Thread Starter
Join Date: Feb 2014
Location: port angeles
Posts: 13
Likes: 0
Received 0 Likes on 0 Posts
How long can I drive the truck with the rad leaking? I check it often. Is it wide to buy a new one or one from a parts yard (auto recycler?)
 
  #5  
Old 02-21-2014
Blossomforth's Avatar
Member
Join Date: Feb 2014
Location: CT
Posts: 39
Likes: 0
Received 0 Likes on 0 Posts
The leak will gradually get worse over time, which could lead to more expensive/time consuming repairs. You could take a gamble on a JY part and hope its not leaky as well, or you can pick up a new one from Rockauto for like $120 shipped.

Radiators are easy to replace, blown head gaskets are not.
 
  #6  
Old 02-21-2014
pearlkid9988's Avatar
Member
Join Date: Dec 2008
Location: Newnan Georgia
Posts: 828
Likes: 0
Received 2 Likes on 2 Posts
Definitely no junkyards i bought one from auto zone that only lasted a year and it was new something that important its worth it to buy a new one and not take unnecessary chances.
 
  #7  
Old 02-21-2014
rangerxl94's Avatar
Member
Thread Starter
Join Date: Feb 2014
Location: port angeles
Posts: 13
Likes: 0
Received 0 Likes on 0 Posts
Originally Posted by pearlkid9988
Definitely no junkyards i bought one from auto zone that only lasted a year and it was new something that important its worth it to buy a new one and not take unnecessary chances.
X

Are the auto zone ones bad? They seem to be the most reasonable. Also my truck doesn't have A/C what Is the small cooling until behind the grill?
 
  #8  
Old 02-21-2014
pearlkid9988's Avatar
Member
Join Date: Dec 2008
Location: Newnan Georgia
Posts: 828
Likes: 0
Received 2 Likes on 2 Posts
I think i just got a bad one and none of the aftermarkets ever do as well as the factory one but most aftermarkets do pretty well. I ended up getting a 4.0l radiator open box from summit and its been in for three years now i think its vista-pro brand its held up great. And the smaller cooler should be for the auto trans it'll have two hoses coming from the bottom one goes to the radiator.
 
  #9  
Old 02-23-2014
rangerxl94's Avatar
Member
Thread Starter
Join Date: Feb 2014
Location: port angeles
Posts: 13
Likes: 0
Received 0 Likes on 0 Posts
Well as luck would have it.... it snowed today so im going to keep checking the fluid and hope i can get her to Thursday so i can replace it.
 
  #10  
Old 03-22-2014
rangerxl94's Avatar
Member
Thread Starter
Join Date: Feb 2014
Location: port angeles
Posts: 13
Likes: 0
Received 0 Likes on 0 Posts
Got her to thursday and replaced radator all is good to go now just to figure out the brake issue
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
vansnxtweek
Exterior Semi-Tech
19
04-29-2008 02:00 AM
Longroad
Drivetrain Tech
16
04-22-2008 09:13 AM
zabeard
4.0L OHV & SOHC V6 Tech
15
07-15-2007 12:11 PM



Quick Reply: Frustrated with Truck



All times are GMT -6. The time now is 08:51 AM.