3.0 fuel flex changeover help
#1
3.0 fuel flex changeover help
Hi guys,glad to be a new member.I have a major problem here.my 99 ranger fuel flex engine is toast.I found a replacement motor but its a straight gas.my question is if I can just change over that engine, if so how and what do I do?can I replace the ecm along with the harness and gas motor without any problems?or should I stay with the fuel flex system.any advice,input or feeback is greatly appreciated.I'm stuck and no one seems to know.thanks
#3
thanks
Thanks wvcat,one more thing.is the fuel inj rail the same.and I can't find the knock sensor and dealer says i don't have one....since you've done this swap no probs yet?no cel?please advice thx again
#4
I didn't even pull the injectors off the rail I just swapped the rails and injectors as one piece. The knock sensor is located behind the head on the passengers side of the engine, If your elecrical plugs are the same you wouldn't have to change it. Yeah I put about 150 miles on the truck and no cel.
#5
thx
I didn't even pull the injectors off the rail I just swapped the rails and injectors as one piece. The knock sensor is located behind the head on the passengers side of the engine, If your elecrical plugs are the same you wouldn't have to change it. Yeah I put about 150 miles on the truck and no cel.
Thread
Thread Starter
Forum
Replies
Last Post
2003stealthedge
2.9L & 3.0L V6 Tech
6
02-16-2019 10:33 PM
mp5raycer
General Technical & Electrical
1
09-20-2014 11:09 PM
jakD
General Technical & Electrical
3
10-15-2010 11:23 AM