if i buy this and take it to a muffler shop can the put it on my truck and make it a dual exuast ??

http://www.flowmastermufflers.com/pr...oducts_id=3297

 

you want 2.5" in not 3"

but yeah your local shop can bend all the pipes for you to make duals

 

As a general rule, you'll lose low end torque as you increase the diameter of your exhaust pipe. It's a back-pressure issue.

 

it will work but you want nothing bigger than 2.5inch... and 2.25 inch is even better... just make sure that if you have them put the pipes out the back that they dont put them too close to the spare tire or else it can get burned by the pipes

 

Yeah but just like they said get the smaller in piece.

 

and get it off ebay... you can get them for like 60 shipped brand new...