06 4.0 starts, runs fine then dies out
#1
06 4.0 starts, runs fine then dies out
Hi- I’ve got an 06 ranger with the 4.0.
For the past month or so this truck has been sitting due to this issue, haven’t had much time to take a look at it.
just yesterday I replaced the intake manifold gaskets, PCV valve, and the PCV valve elbows.
When you start the truck, it’ll run fine for a few seconds, then start to sputter and eventually die. Giving it throttle only chokes it out even more.
No check engine codes, fuel pressure is good.
Any ideas? Thanks
For the past month or so this truck has been sitting due to this issue, haven’t had much time to take a look at it.
just yesterday I replaced the intake manifold gaskets, PCV valve, and the PCV valve elbows.
When you start the truck, it’ll run fine for a few seconds, then start to sputter and eventually die. Giving it throttle only chokes it out even more.
No check engine codes, fuel pressure is good.
Any ideas? Thanks
#2
RF Veteran
iTrader: (1)
Thread
Thread Starter
Forum
Replies
Last Post
excorcist
General Technical & Electrical
2
10-19-2015 05:59 PM