Alright this is beyond annoying.
I litterally just painted my truck on Tuesday got a new windshield on wednesday and got the entire truck put back together today. Low and behold I start it up and It cranked over and cranked over and nothing. I have spark and I sure can smell fuel on the spark plug so why would it not start?

I also went to check codes and how confusing does it have to be? There was one sweep at the very begginning and a long pause. Is this a one or is that the start of the codes?

On that note if it isn't a one then the code I got said I have a bad clutch switch circuit failure.

If anyone could chime in with thoughts that would be great.

 

If it is a bad clutch switch wire, the truck won't start. It isn't reading that the truck is in gear, and because of this it will not start.

 

I went back outside and tested the codes

I got a 67 then 95 then 67 then 95

It then quit and then flashed 95 two more times

The manual says 95 is Fuel pump circuit open- EEC processor to motor ground

and 67 is neutral drive switch orclutch switch faliure

What is this can anyone help?