Need Answer Quick!!!!!!
How hard would it be to put a 4.0 out of an 03 Ranger in my 84 Ranger.
Need Help Quick!!! Time is priceless. |
all it takes is time an money!! lots of both :wink:
|
I'm not to worried about the time but what am I looking at is the mounting of the motor how much is involved in swapping them out. Motor mounts, stuff like that
|
im sure there will be a lot of extensive fabrication, maybe even a whole front frame section, im not sure how the frames have changed since then, you may be better off with a body swap to a wrecked newer ranger.
|
Honestly I don't think it's ever been done. I do know that isn't not hard to get a working 5.0 into an 87 ford ranger, with working heater, ac, all power components. So I doubt it's too hard, The only problem I see is all the wiring.
|
It would probably be easier and cheaper to put a V8 in it.I think you can buy alot of the mounts,brackets,headers ,ETC. prefabbed for a v8 swap.
|
Ok I'll let it go then there was a 4.0 on ebay for 100 bucks with 25000 miles and comes with the computer. I could use a newer motor something with some more ballz.
|
u will need a radiator, maybe transmission, or bell housing, exhaust, u will prolly have to fab motor mounts, possibly steering shaft mods, gauges(eec-v requires mil) pats sysem wiring(which means a newer pats key and ignition switch.... I will check into more
|
Don't worry about it I changed my mind. Thanks though.
|
lol no prob
|
becouse ypu have an older carbed truck it would be very difficult
|
All times are GMT -6. The time now is 10:00 AM. |
© 2024 MH Sub I, LLC dba Internet Brands