truck dies in drive and reverse
 

Gotta keep it on the gas. Truck is an automatic, gotta put it in nuetral at a stoplight then when in drive or reverse it sounds and feels like a manual transmission when you dont push the clutch in coming to a stop or like youre taking off in too high of a gear. any idea? REALLY dont want to pay $85 for a diagnostic test if I dont have to...

any lights on the dash?

mine did similar, but had a flash overdrive light, turns out the intermediate speed shaft sensor on the tranny wasn't reading and it was keeping it in 2nd at lights

Oh boy, not another problem with this thing! lol

Like above, any dash lights?

Check engine was on but I cleaned my battery terminals and its not on yet.

Do you know what code it was throwing?

Said missfire on cylinder 3

Nobody else has any idea?

sounds like a leak, wait and check for check engine light but mine does similiar and i have an intake leak.

try cleaning or replacing the idle air control valve it has been known to stick and when a load is put on the engine at idle like when putting it in gear the engine will shut off, some times it will some times it wont kick a check engine light. good luck

I'm guessing the torque converter. Had a ranger in the shop that did this exact same thing.

Mine was doing this. I changed spark plugs/wires, fuel filter, cleaned maf/tb/iac, and it went away. Not sure what fixed it. I never had a check engine light though.

I thought plugs and wires a little bit too but it would do it in nuetral and park also Id imagine.

If it idles fine in park and neutral, put it up on jack stands and click it into drive, if it stays running with your foot off the brake and the tires off the ground, step on the brake and see if it stalls. If it does the torque converter is staying locked. either from a faulty converter or a faulty converter control solenoid or circuit

Ill give that a try, thanx Justin