Got my new OBDII Global Scanner!!!
#1
I picked up a Mac Tools global OBDII Scanner and am in love with it. I can check, clear, look up, and troubleshoot codes. I can view live data. So far I have found out that my tach, speedometer and fuel gauges are off. I can see incoming air temps, ignition advance, amount of air the engine is pulling in, calculated load on the engine...I am in love. I hook it up and have it in the floor where I can glance at it
#4
#6
#9
Nice!
Here's mine: http://www.scantool.net/products/elmscan_pwm.htm Cost is ~$100. Less if you come up w/ your own enclosure. Software is available for free from the 'net.. Notice mine is scan only. It DOES NOT SET any codes, although it can clear trouble codes.. I think! Has been a while since I've played w/ it.
Here's mine: http://www.scantool.net/products/elmscan_pwm.htm Cost is ~$100. Less if you come up w/ your own enclosure. Software is available for free from the 'net.. Notice mine is scan only. It DOES NOT SET any codes, although it can clear trouble codes.. I think! Has been a while since I've played w/ it.
#13
Thread
Thread Starter
Forum
Replies
Last Post
Azaraith
General Technical & Electrical
2
09-20-2020 06:39 PM
mhue
General Technical & Electrical
3
02-17-2015 11:04 AM