np435 mated to a 302 and twin stick 205
#1
#5
#6
I'm in PA, just north of Reading. It's not twin-sticks, if that is what you were hoping. But the stock linkage is all intact. The truck was a short bed, I think. I'm not sure. I cut the body off of the truck and now its just the frame, suspension and axles. If the linkage is what you want, I'll sell it to you.
These are the most recent pictures I have of it. I could take measurements if that helps more.
(Scroll Towards the bottom)
Build Thread
These are the most recent pictures I have of it. I could take measurements if that helps more.
(Scroll Towards the bottom)
Build Thread
#7
na, single stick would be fine, for my purposes i really dont need a twin stick, but if i had to i had to lol, and the driveshafts arent still on that truck are they, shoot me a price for the shifter linkage. and the driveshafts if u still have them
and if u could measure up the wheelbase of that truck lemme know, center of wheel to center of wheel, that is if ur not using the drive shafts
and if u could measure up the wheelbase of that truck lemme know, center of wheel to center of wheel, that is if ur not using the drive shafts
#8
#11
#13
they didnt come in anything like that, as u can see in the picture, they have seperate shift rods that control the front and rear outputs on the transmission, so as in the first pic that is the simplest setup for a twin stick 205 u can run, for when u was 4low front wheel drive only
#15
Thread
Thread Starter
Forum
Replies
Last Post
BLK02
OLD - Interior, Exterior, Electrical, & Misc.
22
02-01-2012 08:17 AM
Dadinator
OLD - Ranger Based Vehicles
9
07-16-2010 08:40 PM
TheBearJeweler
OLD - Ranger Based Vehicles
28
05-09-2009 12:17 PM
jaycheetwood
OLD - Ranger Based Vehicles
33
03-19-2009 06:16 PM