help with system
hey guys my friend has a problem with his system, he has a MA 121XQ and a MA 689i amp and when he tries to turn up the amp the red light comes on, it shuts off until you turn it down.. anyone know why it owuld be doing this?
-thanks |
whats the watts on the sub and the amp???
|
Sounds like an overheating problem in the amp or there is high resistance in a circuit internal to the amp and it works fine with low current and can't handle high power.
|
sub=600, amp=800 maxed, rms for the sub is 300 and for the amp is 400 rms
|
he can only turn the volume up about halfway around 20 , if he goes higher it cuts off
|
and he says its not overheating
|
too low guage wiring?
Blown fuse? |
ohm load may be too low what voice coil configuration is the sub? recheck ground and mount it to solid area that is free of oxidation, paint etc... then use a washer with two screws thru it so it does not move. i would definitly check the ohm load you are working with first and what the amp can handle.
|
probably has his gains too high.. turn them down. it's going into protection mode (the amp will stay on, but won't allow itself to power anything) until you correct it (turn it down with the volume knob, or turn the gain down on the amp itself). anyhow, turn down the gains.
|
Originally Posted by Strider0O0
probably has his gains too high.. turn them down. it's going into protection mode (the amp will stay on, but won't allow itself to power anything) until you correct it (turn it down with the volume knob, or turn the gain down on the amp itself). anyhow, turn down the gains.
|
All times are GMT -6. The time now is 04:56 PM. |
© 2024 MH Sub I, LLC dba Internet Brands