Headunit Mounting
#1
Headunit Mounting
i had the my headunit stolen the other day and im going to replace it. The thing is the thief ripped the old one out and I need to figure out how the unit itself is mounted to the truck so I can buy the parts to put a new one in. All I can see now is a hole where it used to be, it has nothing inside.
Any drawings, pictures, etc would be very helpful.
Any drawings, pictures, etc would be very helpful.
#5
Originally Posted by jodynich
I have a 02.. I think they yanked out the radio track too.
Wait.. no they didn't. The only problem is that they ripped off the bezel and the little mounting tabs along with it. The bezel still "pops" in so *hopefully* it will turn out all right and stay in without the screws. I just need that metal cage that the radio sits in.
#6
#7
#8
that metal cage you're talkin about mounts to a dash install kit, which you may have to buy since it sounds like you don't have one anymore. anyway, once you have that, put the metal sleeve in it, and bend the little tabs (on the metal sleeve) down to lock the metal sleeve in. it shouldn't move once you bend down the appropriate tabs. after that, the headunit (assumming its an aftermarket headunit) should slide into that metal sleeve, and catch itself at the end and lock itself in place. when you buy a new headunit, you'll get a metal sleeve with it.
sorry i dont have any pictures.. it's an easy install though, so if you have any questions, there will be lots of guys on here that could probably help ya out
sorry i dont have any pictures.. it's an easy install though, so if you have any questions, there will be lots of guys on here that could probably help ya out
#9
#10
Thread
Thread Starter
Forum
Replies
Last Post