Capasitor question?
#1
Capasitor question?
Ok well I just got all my amps and new capacitor hooked up yesterday. Sounds sooooo much better you would not believe me if i told you. The question is how do i get it to stay of when the ingnition switch off? There is no remote line i can run to it. at least i didnt see any. When the truck is off, the cap will come on for bout a minute or so than turn off for like 2 minutes. Any ideas? Ill look over it again but thats whats happening as of now. This is it below,
#2
#7
#10
hmmm.....take a reading from the output side with a DC multi meter and see if you are getting any current...it might just be the way the CAP is designed and it may just keep doing that untill all of the stored juice is used up...5 farads is quite large....
Also did you make sure that your remote wire for your amp is properly installed?
Also did you make sure that your remote wire for your amp is properly installed?
#12
#13
Originally Posted by Kanoeking
hmmm.....take a reading from the output side with a DC multi meter and see if you are getting any current...it might just be the way the CAP is designed and it may just keep doing that untill all of the stored juice is used up...5 farads is quite large....
Also did you make sure that your remote wire for your amp is properly installed?
Also did you make sure that your remote wire for your amp is properly installed?
Thread
Thread Starter
Forum
Replies
Last Post
Masteratarms93
General Ford Ranger Discussion
4
04-29-2010 01:18 PM
buggman
General Technical & Electrical
1
11-19-2008 11:00 AM
ranger_1999
General Ford Ranger Discussion
22
11-05-2008 08:31 AM