Air INtake System
#4
No one makes one, K&N made one for the 01-03 duratecs but the MAF changed in 04 and they wont work on the newwer one's. You could build a spectra intake like they did here.
http://www.truckinweb.com/tech/0909t...dup/index.html
http://www.truckinweb.com/tech/0909t...dup/index.html
#7
^Really is a short ram by definition even with a heat shield, atleast by honda-tech standards. Though the maf thing is nice to know about if your really going for it and i keep that page bookmarked aswell just incase.
What I did was remove the rubber tube, and intake silencer. Cut a piece of my 2.5" integra cai to fit from the throttle body to the air box(yes it has been proven by scan gauge here to raise intake temps over stock rubber tubing) even with the plastic from the fan shroud as a heat barrier, ran a new $14 wix element, jb welded a 3" plastic spectre adapter in place of the stock silencer, and routed a 3" spectre flex tube with a 4-3" pvc adapter stuck in place of my foglightless 08 front bumper plug.
In all honesty even with "ram air" I notice no difference in either power or throttle response(even if it thought i had i wouldnt admit to a butt dyno) which is what i expected since i didnt install a pwjdm whale pen!s or tune for it. It also doesnt sound any different then just a silencer delete with 2.5" tube, which sounds worlds better then a 4cyl with a stock intake and a muffler.
What I did was remove the rubber tube, and intake silencer. Cut a piece of my 2.5" integra cai to fit from the throttle body to the air box(yes it has been proven by scan gauge here to raise intake temps over stock rubber tubing) even with the plastic from the fan shroud as a heat barrier, ran a new $14 wix element, jb welded a 3" plastic spectre adapter in place of the stock silencer, and routed a 3" spectre flex tube with a 4-3" pvc adapter stuck in place of my foglightless 08 front bumper plug.
In all honesty even with "ram air" I notice no difference in either power or throttle response(even if it thought i had i wouldnt admit to a butt dyno) which is what i expected since i didnt install a pwjdm whale pen!s or tune for it. It also doesnt sound any different then just a silencer delete with 2.5" tube, which sounds worlds better then a 4cyl with a stock intake and a muffler.
#8
ES894x4 I have read somewhere that ceramic rattle can paint can reduce custom intake tube temps...maybe even header wrap? Just a thought, but at this point you probably don't care since it did nothing for performance to begin with lol. There is always that glint of hope when you have a 4 banger though...
Thread
Thread Starter
Forum
Replies
Last Post
For Sale: K&N FIPK COLD AIR INTAKE SYSTEM
07silver4.0Lsport
OLD - Engine & Drivetrain
4
02-20-2010 02:48 PM
For Sale: 3.0L K&N Cold Air Intake System in PA
yvillanz98
OLD - Engine & Drivetrain
4
11-08-2009 05:50 PM
RangerRunner96
2.9L & 3.0L V6 Tech
5
08-29-2008 01:01 PM