Broken pinion shaft
#1
Broken pinion shaft
I have a 2wd 2000 ranger 2.5l. I snapped the pinion shaft right where the locking bolt goes through. The shaft goes through so far, but stops when it hit's the large gear. How do I pull it out? As you can tell I don't know alot about working on this and I have a small budget.
#3
#5
From all the videos I watched that's how I found out about the shaft not clearing the large gear on 7.5 rear ends
Thread
Thread Starter
Forum
Replies
Last Post
TomJones
General Technical & Electrical
7
12-19-2014 04:25 PM
Crunchy
General Technical & Electrical
0
09-05-2011 03:17 PM