U joints :(
#1
#7
Originally Posted by Redneckstone
https://www.ranger-forums.com/forum2...ad.php?t=20868
can be done with out using a vise.. personally i recommend NOT using one at all...
can be done with out using a vise.. personally i recommend NOT using one at all...
crap im slow
#12
#16
Just an odd tip, but if its hot out and the grease in the bearings is fluid and the bearing rods keep moving, you can throw the new universals in the freezer a couple hours so everything stays in place and it should help them fit in a little better.
Odd idea I know. Don't know how many people that's a problem for.
Odd idea I know. Don't know how many people that's a problem for.
#17
hahaha!! i should, id ask bf... but he hates FORD with a passion OMG its not even funny... and i should ask one of the guys from str... but i think bf would get pissy (its a loooong stupid story).. ill make my dad get off the couch and help me, he knew what it was before i did. and its been soo cold here - i dont think the heat will do alot of damage... ill make sure it hasnt been driven yet or has cooled down if i drove it anywhere! thanks for the heads up!!
andy - i know - i posted there too yesterday, i miss everyone -- hope theyre all doing well :)
andy - i know - i posted there too yesterday, i miss everyone -- hope theyre all doing well :)
#19
#20
Originally Posted by Sparki
will do fletch!! thanks!
man i just looked at the how to on this... holy crap... this is not going to be fun... im going to attempt it by myself... if not... im going to make my dad help me.. ill take pics of my progress.. im sure ya'll will find it amusing... lol
man i just looked at the how to on this... holy crap... this is not going to be fun... im going to attempt it by myself... if not... im going to make my dad help me.. ill take pics of my progress.. im sure ya'll will find it amusing... lol
shouldnt be too bad. Just lube em up extra good. hammer and punch and hammer away!!!!!
#22
#23
#25
lol i know.. i used an impact... (F-R) it was switched to R lol. unfortunately i only have a 13mm socket like that in a reg ratchet... ive tried - i got the entire shaft to move... but not that f**kin bolt to move... go fig..
my dad just gave me a can of PB Powerful Penetrating Catalyst... im gonna go spray that on there and see what happens... wish me luck
my dad just gave me a can of PB Powerful Penetrating Catalyst... im gonna go spray that on there and see what happens... wish me luck