Front Driveshaft Fell Apart need help asap
#1
Front Driveshaft Fell Apart need help asap
I was putting my front driveshaft in my 98 ranger and the front driveshaft cap fell off the one end and all the ***** fell out that are int eh end near the transfer case. i cannot figure out how it goes back together. I got it back together and put it under the truck and it is abotu 1/4'' too short. any help is greatly appreciated
#2
#3
I have all the ***** in their slots and i am putting the u-joint side in last. when i have the t-case side in place and i pull the shaft toward the diff, it is too short. i put the ***** and the keeper on ther undercut in the shaft that is behind the splines then slid it into the other piece and put the cap on. it seemed to be correct but too short
#5
it pivots around. when i fully push it in it does not move witht he other piece that the cv's go into. it just moves by itself. if i pull it back out it is fine but still too short...ill have to try in the am to get it back together. is there only one way it can go back together? do i have to match the shaft with the cv holder?
#6
Thread
Thread Starter
Forum
Replies
Last Post
Want to Trade: My Aluminum Driveshaft for your Steel Driveshaft - WA
wellcom2knoxvile
OLD - Engine & Drivetrain
2
08-23-2010 07:17 AM
Dangerranger01
Exterior Semi-Tech
34
07-28-2009 12:52 AM
DanNEBTD
General Technical & Electrical
2
12-22-2005 07:56 PM