Rubber like seal found on front driveshaft.....?
#1
#3
Originally Posted by lifted97ranger
i don't think mine as that.....i wouldn't worry about it...pull it out and replace the u-joints while that driveshaft is out....
Yeah I replacing all 3 u-joints and going to give my front drive shaft a nice coating of paint. Already sanded the upper part of the driveshaft down already. This last u-joint is being a pain. I have it here up in my shop a work. Presses work wonderful!
#4
#5
[QUOTE=fletch12518]
Superlift doesn't make a driveshaft for a '97 and older Ranger.......that is only for the '98+ Rangers.......
i have the exact same drive shaft as you.....i will look when i get home.....was that at the t-case or the axle?
Originally Posted by lifted97ranger
i don't think mine as that.....QUOTE]
yours wouldnt have it if it has the superlift driveshaft.............but your stock one should I'm sure.
yours wouldnt have it if it has the superlift driveshaft.............but your stock one should I'm sure.
i have the exact same drive shaft as you.....i will look when i get home.....was that at the t-case or the axle?
#6
#7
Originally Posted by lifted97ranger
Superlift doesn't make a driveshaft for a '97 and older Ranger.......that is only for the '98+ Rangers.......
i have the exact same drive shaft as you.....i will look when i get home.....was that at the t-case or the axle?
i have the exact same drive shaft as you.....i will look when i get home.....was that at the t-case or the axle?
The transfer case my man........
#8
Originally Posted by hosse
You need a Double Cardon Joint ball seat repair kit. Driveshaft shop will be able to help you with that. The dealer might also help but the price could be a little high.
Mike
Mike
I got it from ford yesterday. I got it all back to gather. Right now got a nice coat of gloss black on the shaft. Looks brand new. I'll get some pics when it is all dried up.......sitting in the paint booth in the shop right now.
#10
#11
Originally Posted by SVTRanger
yeah man i just pulled my driveshaft out last night to do the same thing. that rubber seal on mine is cracked all over the place. im just having a hard time gettin the old ujoints out. its hard when you dont have a press and all you got is a BFH
Ship it out than lol. Jk. Take some heat from a little propane tourch to it and get a BFH (BIG FUC*ING HAMMER) Heat steel surrounding the u-joint, than knock it on through. That works. Also what helped me out even more was spraying wd-40 every afternoon on the joints for one month strait.
Thread
Thread Starter
Forum
Replies
Last Post
1996Ranger4x4SuperCabSTX
General Ford Ranger Discussion
9
12-10-2019 03:07 PM
Bird76Mojo
4.0L OHV & SOHC V6 Tech
7
08-26-2011 03:50 PM
KLC
OLD - Engine & Drivetrain
6
06-21-2010 07:34 PM