locker on a 28 spline
#1
locker on a 28 spline
hey guys.... im thinkin of puttin a detroit elocker in the rear of my 06. i wish it had 31's but its got 28's, my ques is will the rearend stay together with the locker in there, i don't do a lot of hard 4wheelin but we do get a pile of snow up here in nova scotia. any advice on what to do with the front dana 35 would be a help too, i hear that torsen will have a lsd that will fit in there commin out this month, but again will the frontend hold up ? what do you think ?
#2
#4
#5
Technically, I think all D35 stuff is the same however before you blast me. The only difference is the circlip groves that retain the axle, which is not present in any lockers other than the Aussie and Lockright. So if you could find someone to machine the groove in your locker (so long as it does not require C-clips to retain the side gears) you could have any D35 locker.
Following all this right?
Following all this right?
#6
Technically, I think all D35 stuff is the same however before you blast me. The only difference is the circlip groves that retain the axle, which is not present in any lockers other than the Aussie and Lockright. So if you could find someone to machine the groove in your locker (so long as it does not require C-clips to retain the side gears) you could have any D35 locker.
Following all this right?
Following all this right?
Thread
Thread Starter
Forum
Replies
Last Post
99fordranger
Drivetrain Tech
19
04-23-2010 06:29 PM
01xltranger4x4
Drivetrain Tech
25
05-18-2007 12:09 PM