I am going to be getting a manual tcase from a buddy of mine. It's the 1354 I believe. I am going to be putting it in my explorer and I needed to know if I will need to modify anything for it to work or if it'll bolt right up.

Thanks!

 

anyone?

 

Anyone?

 

PM sent

 

I assume the explorer is 4wd? I did the opposite. Took an explorer 1354 and installed on my ranger. i had to swap out the flanges between the two 1354's.

 

if its 4wd it should. rangers only had 1350s and 1354s all which have the same bolt pattern. might have to swap the flanges like Wayne said.

 

It is 4wd. I was also wrong it is a 1350. I though it was a 1354, but was corrected.