98 ranger not going into 4wheel drive
#1
98 ranger not going into 4wheel drive
Hey guys,
I've got a 98 ranger that when I try to put it into 4x4 , I can here the relay click a few times then the 4hi and 4lo light flashes 6 times then goes out and will flash 6 times every so often. When I first took off the shift motor I was able to get it to go from 2x4 to 4x4 and back a couple times then it stopped.
I also found my vacuum lines that are plugged into the hub are dry rotted. I disconnected the bad line from the good line , plugged the good line. And tryed to see if it would go ahead and put the transfer case in 4hi when I hit the switch. No Luck!
My questions are
1. To the shift motor I have 3 wires with pulsing current coming in, should there be more?
2. If the front wheels don't lock in, will it keep the shift motor from working?
Thanks!
I've got a 98 ranger that when I try to put it into 4x4 , I can here the relay click a few times then the 4hi and 4lo light flashes 6 times then goes out and will flash 6 times every so often. When I first took off the shift motor I was able to get it to go from 2x4 to 4x4 and back a couple times then it stopped.
I also found my vacuum lines that are plugged into the hub are dry rotted. I disconnected the bad line from the good line , plugged the good line. And tryed to see if it would go ahead and put the transfer case in 4hi when I hit the switch. No Luck!
My questions are
1. To the shift motor I have 3 wires with pulsing current coming in, should there be more?
2. If the front wheels don't lock in, will it keep the shift motor from working?
Thanks!
Thread
Thread Starter
Forum
Replies
Last Post
benawall
Drivetrain Tech
8
07-29-2019 12:23 AM