Do I need a new tranny?
#1
Do I need a new tranny?
I have 95,000 on my tranny right now. It seems to shift fine when the slave cylinder isn't acting up but I have been slamming it into gear when the slave was acting up. I figure I'm going to have the clutch done real soon and why not change the tranny as well. I found a rebuilt one from Kormex Transmission for $550. Do you think I need it?
#7
Originally Posted by Ranger Carl
yes, if you keep slaming it in gear you will need to replace the syncronizers but the rest may be ok.
#9
When my slave went, I had to turn it off to get it into first. Seemed a beter alternative to slamming it into gear. I have replaced the slave, but can't quite get it bled all the way. I just have to give the engine a little rev so it will slide into first. I need to bleed it some more, but can't seem to find the motivation.
#10
#11
#12
Thread
Thread Starter
Forum
Replies
Last Post
lifted97ranger
Drivetrain Tech
19
11-26-2007 12:12 PM
PickupMan92
General Technical & Electrical
4
07-31-2004 10:41 PM