Picture Request: Manual transmission with BL & w/out & with a shifter extention.....
#1
Picture Request: Manual transmission with BL & w/out & with a shifter extention.....
looking for pictures of a manual transmission shifter in a truck with a body lift and no shifter extention......i want to see how low the shifter ball sits.....
also, if you have pictures of a manual transmission shifter in a truck with a body lift and a shifter extention installed, i want to see pictures of the shifter location...
also, if you have pictures of a manual transmission shifter in a truck with a body lift and a shifter extention installed, i want to see pictures of the shifter location...
#2
I dont have any pictures but about 6 years ago i had a 1996 Ford Ranger XL 4x4 with a 3 inch BL and no shift extension. The shifter sat a little low but wasnt all that big of a deal to me. I had to do some cutting of the plastic piece that goes around the shifter so that i could get it into 2nd, 4th and reverse.
#3
#4
You're using the LII arm right? I don't have pics of mine without the extension and with the original cup holder console, but it needed no trimming with that arm because of its shape. I actually liked the way it felt more without the extension, but when I went to the twin stick boot setup the boot came up to high on the arm so I had to put the extension in.
#5
yea i am using the Level II arm (hope it is here by the weekend so i can do the swap!).....i might just have to try it.....is it hard to put in the extention after the tranny is in the truck? i bet it could be done by just removing the floor hole cover plate.....
i am also going to be using a Level II shift boot....
i am also going to be using a Level II shift boot....
#6
#8
Thread
Thread Starter
Forum
Replies
Last Post
ranger024x4
1" & 3" Body Lifts
2
08-02-2011 03:00 PM
RangerMuse
General Ford Ranger Discussion
19
09-17-2008 01:49 PM