Transmission removal and installation
#1
Transmission removal and installation
Hey guys im new to all this and i want to know how to replace a new transmission in my 1999 ford ranger automatic 2 wheel drive i think its a 2.3 liter
engine and what not keep in mind im new to all this please reply with any videos or suggestions thanks
engine and what not keep in mind im new to all this please reply with any videos or suggestions thanks
#2
Its not to bad remove shifter form inside cab remove crossmember while you have the trans supported drop the driveshaft remove starter and bell housing bolts then slide it back slowly until the input shaft clears the pressure plate and drop it down its not to bad at all but might want an extra set of hands putting it back in.
Thread
Thread Starter
Forum
Replies
Last Post
Tanker3278
DOHC - 2.3L Duratec / Mazda L Engines
33
12-17-2020 12:24 AM
Kevin81
General Ford Ranger Discussion
0
09-18-2014 02:18 PM
energylaw
Drivetrain Tech
3
06-19-2014 10:59 PM
Hawklore
General Technical & Electrical
9
05-01-2011 06:05 PM
aftermarket
Exterior Semi-Tech
12
07-31-2006 09:06 AM