Anyone want to trade an auto for a manual?
#1
#3
yeah I miss my manual shifter.....I bought this because it was a great truck at a huge discount brand new, I only had 2 choices, a red edge with a manual and a 4.0 2 door or a 4 door XLT 4.0 auto. The edge was more too, I would of thought it should have cost less. I searched every dealer within 40 miles of me over a weeks time and just bought this one.
Can anyone help? How about starting with what years the manual tranny that my truck should have came in are and if there is a specific identification number or name for it, like my 5rreereerr (however many e's and r's are there) auto? Don't rangers have hydraulic clutches? I am sure I need a computer swap as well, right? How about tranny crossmember mounts? IS my driveshaft the same length and will it slide right into the manual tranny? Tahnks
Can anyone help? How about starting with what years the manual tranny that my truck should have came in are and if there is a specific identification number or name for it, like my 5rreereerr (however many e's and r's are there) auto? Don't rangers have hydraulic clutches? I am sure I need a computer swap as well, right? How about tranny crossmember mounts? IS my driveshaft the same length and will it slide right into the manual tranny? Tahnks
#4
#5
#7
Unless you are planning on keeping this truck for, well ever. it will be cheaper and better just to trad ein for the transmission you want. I would put this one step below converting 4x2 to 4x4, in as the steps and s\cost required to do it totally more then the depreciation of trading in.
#8
#9
Thread
Thread Starter
Forum
Replies
Last Post
EMB1230
OLD - Ranger Based Vehicles
2
08-25-2010 10:33 PM
Detox
General Ford Ranger Discussion
27
04-22-2010 01:56 PM
04blackedge
OLD - Interior, Exterior, Electrical, & Misc.
1
05-07-2009 04:43 PM