need front end help!!!
#1
need front end help!!!
i went off roading yesterday, and i kept hearing this clunking sound from the front wheels, when i got home i took the wheels off and the outer part of the auto hubs, when i grab the splined shaft sticking out (axle) i can move it up and down like an 1/8 inch. is that supposed to move? and if not what do i replace the wheel bearing? also if i replace the lower ball joints do i need to get an alignment?
#2
#4
There isn't a pinch bolt or nut on the TTB rangers, that splined shaft, Outer drive shaft can move a little with the hub off. If you replace the ball joints I would get an alignment, it's $50 and will save your tires. Jack the truck up and wiggle the tire back and forth with a buddy looking to see whats moving.
4.0 L for sure have the Dana 35
4.0 L for sure have the Dana 35
#5
There isn't a pinch bolt or nut on the TTB rangers, that splined shaft, Outer drive shaft can move a little with the hub off. If you replace the ball joints I would get an alignment, it's $50 and will save your tires. Jack the truck up and wiggle the tire back and forth with a buddy looking to see whats moving.
4.0 L for sure have the Dana 35
4.0 L for sure have the Dana 35
Thread
Thread Starter
Forum
Replies
Last Post
01_Camaro_SS
Exterior Semi-Tech
7
12-20-2016 05:00 PM