I've have rebuilt my motor and reinstalled it but now when its running i cant put it in gear and when i try to start it in gear it wants to take off. so what do ya'll think it is or could be?

 

manual?

 

yes

 

clutch issue to me...clutch is not properly disengaging. Check out your linkage/cable or your slave and master cyl. I put linkage/cable there because i have no clue as to if you upgraded that equipment.

Either those or possibly your shift rails are jammed up.

 

hmmm i just bleed the clutch so it seemed like the slave was working since fluid was flowing through it but idk =( what should i look for??

 

did you install the clutch disk backwards? did you use a new pilot bearing? did you put a new slave in and get it all bled correctly?

 

no my clutch isn't backwards no i didn't install a new slave and i think im bleeding it correctly

 

Anytime you have access to the slave you should change it. It's cheap insurance to keep things like this from happening.

Try bleeding the master.

 

fixed it just had to bleed the S*** out