Transmission seal
 

Has anyone else had the seal on the back end of your automatic transmission just pop out? Mine did and i went to take the bolts out to take off the drive shaft and it seems near impossible to get the last 2 out if you have any ideas on how to get them out please let me know
https://cimg6.ibsrv.net/gimg/www.ran...2ba29ebfbf.jpg

The 4 bolts on the rear differential?
Should just unscew

Block front tire
Shift trans to Neutral
Jack up ONE wheel on rear
Turn drive shaft to get better angle on remaining bolts
Put trans back in Park

You should mark the one hole so drive shaft goes back on the same way

So i got it fixed and drove it to work and back but now its popped back out an 8th of an inch and shooting steam out when it drips a little my main mechanic has never seen anything like that before

All transmissions have a vent, maybe yours is clogged up which allows pressure to build up inside and pushes out the seal.

Vent is at the top rear but has a metal loop that runs up to top bell housing and back down to drivers side of trans

So i think i have it figured out the tail stock on my transmission is cracked so im hoping once iget that changed it will be fixed

Fluid leak between transmission and t case