CV re-install - Need help ASAP
#1
Join Date: May 2005
Location: Jackson, New Jersey
Posts: 4,872
Likes: 0
Received 0 Likes
on
0 Posts
CV re-install - Need help ASAP
I have just replaced the axle seal on the passenger side of my truck. I have popped the CV back into place, but I can't tell if it's in the right spot. There is about a 5/16" gap between the CV and the axle housing. I have tried pulling the CV out, rotating it and putting it back in, but it doesn't want to go any further. Does this seem right, or is there something that I'm not doing here.
Thread
Thread Starter
Forum
Replies
Last Post
rybread5520
General Technical & Electrical
2
01-02-2009 09:41 PM
jaycheetwood
General Ford Ranger Discussion
2
10-07-2008 07:42 PM
TippnOver
Interior Semi-Tech
7
02-02-2005 11:56 AM