IFS D35 4.56 Gears and Timken Bearings - MN
 

Everything you need to swap your Dana 35 axle to 4.56 gear ratio! Bring your engine and transmission back to their factory RPM range and restore that lost torque from your big mud tires!

Brand new never installed Superior ring and pinion set for the IFS Dana 35 axle. (98 and up Rangers) LINK

Brand new Timken bearings/install kit. LINK

I paid $175 for the ring and pinion gears and $85 for the bearings/install kit. That is $260! I will make you a great deal and give you both for just $200! These are the parts you need at a great price!

https://www.ranger-forums.com/attach...ine=1380679955
https://www.ranger-forums.com/attach...ine=1380679955
Top red Ratech box and bottom Superior box, not center black box. :biggthumphttps://www.ranger-forums.com/attach...ine=1380679955

Nobody needs this stuff?

Make me an offer on it I can't refuse!

I need 4.56s, I wish I could swap them myself. Install cost is high

Shouldn't be too expensive.

I am having a gear change and it SHOULD RUN around

$500 for labor but I am hoping for a little less, maybe that is high...

I swapped them myself on my rear axle of my 2wd, it's not bad at all. Send me your diff and I will put them in and send it back, haha!

If I sent you my 8.8 and the 200 bucks would you put it in and send it back? I pay for shipping lol email me at jacob.mccurry19@gmail.com

I was referring to the front diff for the record. You could still drive your truck without the front diff making my proposal feasible. If you meant the front diff I'll do it, it's seriously that easy. But if I were you I would do it myself, it's not too bad.

this is only for the front right ? or is it both ?

That's correct, this is only for the front diff.

Will you take 175 shipped ? Ill buy it right now

Sent you a pm.

did these items sell?