Manual T-case Conversion Items and miscellaneous stuff: New Mexico, USA - Ranger-Forums - The Ultimate Ford Ranger Resource


Engine & Drivetrain Ford Ranger engine and drivetrain parts, i.e. radiators, driveshafts, knuckles, brakes.

Closed Thread
 
LinkBack Thread Tools Search this Thread
  #1  
Old 02-17-2009
Lefty04LevelII's Avatar
Member
Thread Starter
 
Join Date: Aug 2005
Location: DFW
Posts: 1,447
Manual T-case Conversion Items and miscellaneous stuff: New Mexico, USA

I hate doing this, but after 2 years of not finding an extension housing I'm putting stuff up for sale. PLEASE do not PM me. I'm at 93% full and would prefer not to delete what messages are left within my inbox. Instead, please e-mail (cnewsom_AT_nmsu_DOt_edu) or call me 5754915092.
  • 5-speed shift boot (x2)
  • 4x4 shift level & boot
  • 2002-2003 FX4 Level II silver shifter bezel (x2)
  • shift linkage and floor panel cover
  • RCM cover (black thing next to t-case)
  • 2002 FX4 manual t-case

I spent hours calling junkyards locating the above parts; my loss, your gain.

Looking to get $250 PLUS SHIPPING for the t-case, that's what I paid 2 years ago.

Would like to sell everything else listed above with each other. One of the silver bezels is a spare parts piece for the other. The mounting points underneath need some TLC, thus why I have 2 bezels. I DO NOT have mounting hardware for the shift linkage. That should be able to be taked down at Ford and for that purpose please use the VIN in the below photo. Asking $200 PLUS SHIPPING for 4x4shifter, panel & linkage, bezels, and boots all together. Brand new the boots alone sell for $200+





Miscellaneous stuff:
  • 2004 Stock front differential with Yukon 4.88 gears (purchased from Big04Ranger)
  • Stock front skid plate without hardware
  • Westin 1-Piece Sportsman Grille Guard with brackets, hardware, and instructions

Asking $200 PLUS SHIPPING for the front diff.

Asking $100 PLUS SHIPPING for front skid plate. The hardware I have is 'custom' from when I had to replace my first skid and re-tap the mounting holes. Replacement skid is OEM purchased through Borman AutoPlex (Ford dealer) here in Las Cruces, NM and it has some scratches on it. It's been sitting in my garage since I put the RCD lift on.

Asking $200 for the Grille Guard, prefer local pickup unless you can figure out shipping. Brackets need to be bent slightly back into alignment, nothing major though, and re-painted to avoid rusting. Some scratches on the guard from been off-road, same reason why the brackets need some attention. Guard has been off my truck since I put the RCD kit on (July 4, 2007). I paid around $450 for it new from Checker Auto Parts.

PLEASE do not PM me. I'm at 93% full and would prefer not to delete what messages are within my inbox. Instead, please e-mail (cnewsom_AT_nmsu_DOt_edu) or call me 5754915092.
  #2  
Old 02-17-2009
redranger4.0's Avatar
Member
 
Join Date: Jun 2004
Location: Firey depths
Posts: 15
how much for just the floor panel cover?
  #3  
Old 02-17-2009
ScottG's Avatar
Member
 
Join Date: May 2004
Location: Lewiston, Maine
Posts: 4,926
assuming you dont want to seperate

do you have any part numbers off the RCM cover (black thing next to t-case)

thanks man!!!
  #4  
Old 02-17-2009
Lefty04LevelII's Avatar
Member
Thread Starter
 
Join Date: Aug 2005
Location: DFW
Posts: 1,447
Andrew....you need the panel only or it and linkage?

Scott...check your pm at exploderforum. I'll see if I can find a number on the RCM, but I think RazorEdge couldn't get anything to match on it. I'll try calling a dealer tomorrow to see if I can get a match off a couple of 03 FX4LII VINs I have somewhere on this computer desk. FWIW, the RCM cover is Bob's (rwenzing) old cover.

As for separating parts...anyone interested in individual items give me a little time to see if I can sell them together. I'll PM those expressing interest once that time has come.
  #5  
Old 02-18-2009
steev's Avatar
Member
iTrader: (2)
 
Join Date: Sep 2008
Location: Grand Rapids, MI
Posts: 138
email sent!
  #6  
Old 02-18-2009
Bumpncarstereo's Avatar
Member
iTrader: (3)
 
Join Date: Aug 2006
Location: btwn the Buff and the Roc
Posts: 1,302
man i so want to buy this.... can you get me an estimate on shipping to 14020?
  #7  
Old 02-18-2009
ranger's Avatar
Member
 
Join Date: Jun 2006
Location: Imperial Beach, CA
Posts: 4,502
Can you get me a quote to shipping the t case to 91932? ive been looking everywhere for one.
  #8  
Old 02-18-2009
ranger's Avatar
Member
 
Join Date: Jun 2006
Location: Imperial Beach, CA
Posts: 4,502
Also, depending on where at in New Mexico, i can probably drive over there and pick it up on a weekend.
  #9  
Old 02-18-2009
mikerider's Avatar
Member
iTrader: (8)
 
Join Date: Oct 2006
Location: Renton WA
Posts: 2,504
Emailed you about the skid plate.

-Mike
  #10  
Old 02-18-2009
steev's Avatar
Member
iTrader: (2)
 
Join Date: Sep 2008
Location: Grand Rapids, MI
Posts: 138
Pretty much everything on the left side of the picture is now mine!

-steev
  #11  
Old 02-18-2009
Lefty04LevelII's Avatar
Member
Thread Starter
 
Join Date: Aug 2005
Location: DFW
Posts: 1,447
holy crap...I checked this post like 30 minutes ago and the only replies were from Andrew and Scott....


UPDATE...

bezels, 4x4 shift lever, linkage, and boots SOLD

floor panel SOLD (if Andrew will send me his blasted address).

Waiting on PM reply from Scott regarding RCM

Ranger - t-case is yours, check your e-mail.

Mike's got the skid plate

ITEM REMAINING:
-Westin 1-Piece Sportsman Grille Guard
-2004 ranger front differential regeared to 4.88
  #12  
Old 02-19-2009
steev's Avatar
Member
iTrader: (2)
 
Join Date: Sep 2008
Location: Grand Rapids, MI
Posts: 138
Yeah I know what you mean...for some reason, replies don't show up for quite some time when posted. I don't post here that often so I'm not sure if that's the norm or not...oh well! This stuff sure didn't last long!

-steev
  #13  
Old 02-19-2009
Bumpncarstereo's Avatar
Member
iTrader: (3)
 
Join Date: Aug 2006
Location: btwn the Buff and the Roc
Posts: 1,302
damn i really wanted to at least get the shifter boot.
  #14  
Old 02-20-2009
Bumpncarstereo's Avatar
Member
iTrader: (3)
 
Join Date: Aug 2006
Location: btwn the Buff and the Roc
Posts: 1,302
steev, the mods and admins approve posts in this section.

*waves hands slowly in front of steve's face Jedi like*

You want to send me one of the shift boots.
  #15  
Old 02-28-2009
steev's Avatar
Member
iTrader: (2)
 
Join Date: Sep 2008
Location: Grand Rapids, MI
Posts: 138
In case you didn't see my email, I got everything yesterday! Thanks again for everything!

To anyone thinking about dealing with Chris (Lefty04LevelII), do it! Great guy, updated me as soon as he sent out the stuff and gave me tracking numbers. Also, everything was bubble wrapped separately and then packed in styrofoam to prevent any scratching. A+ job.

-steev
  #16  
Old 02-28-2009
ranger's Avatar
Member
 
Join Date: Jun 2006
Location: Imperial Beach, CA
Posts: 4,502
Yea, he packed the hell out of the tcase when i met him in New mexico. Great guy. Great seller would recommend to anyone
  #17  
Old 03-04-2009
TrePaul86's Avatar
Member
iTrader: (8)
 
Join Date: Apr 2007
Location: Gresham, OR
Posts: 1,369
So what's shipping on the front axle to 97080? That's something I may be interested in pending price...
Closed Thread

Related Topics
Thread Thread Starter Forum Replies Last Post
2000 Mazda b4000se for $2500 located in USA - New Mexico. B4000zx Ranger Based Vehicles 1 05-06-2014 05:06 PM
For Sale: Clearance Items+Rare Stuff: White/Silver Guage cluster, reg cab cup holder: AR TheBearJeweler Interior, Exterior, Electrical, & Misc. 15 03-15-2011 02:53 PM
For Sale: 06 level 2 stuff for sale: New Mexico BILTRITE BULLIES Interior, Exterior, Electrical, & Misc. 42 01-28-2011 12:08 AM


Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off



All times are GMT -6. The time now is 06:07 PM.


We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.