Ranger-Forums - The Ultimate Ford Ranger Resource

Ranger-Forums - The Ultimate Ford Ranger Resource (https://www.ranger-forums.com/)
-   Exterior Semi-Tech (https://www.ranger-forums.com/exterior-semi-tech-39/)
-   -   adding fogs to 94 (https://www.ranger-forums.com/exterior-semi-tech-39/adding-fogs-94-a-66889/)

Ray_Welder 06-23-2008 12:00 AM

adding fogs to 94
 
I hate to ask this because I'm its been covered at some point, But I searched this and was only able to answer bout half of my question. I was under my truck the other day and seen that it had a plug for fogs. I know I'd need to add a relay and switch, What I need to know Is where is the wiring for the Switch? I wont need a valence because I'm planning on putting two lights behind the grille for driving lights.
Any help would be greatly appreciated.

RedOctober 06-23-2008 12:10 AM

Yeah almost all rangers are wired the same way... you found the prongs in the wireing harness for fogs...

I had the same thing on my 96. the switch for a 96 w/fog lights was on the dash near the HVAC controls/stero.. One day I pulled the dash apart to install a new stereo, sure enough there sat the wire and connector for a foglight switch attached to the back of the plastic dash where the switch should have been.,..

Weren't the 94 and later models fog swith intergrated into the headlight switch???

Ray_Welder 06-23-2008 12:15 AM

Thats what I was wondering, I didnt know if it was built in the headlight switch or what. I was actually going to test that tomorrow.

Ray_Welder 06-23-2008 12:17 AM

Well I guess I'd need a relay for that.

Lone Ranger 93 06-23-2008 08:21 AM

My 93 didn't have fogs from the factory, however I put em on but didn't use any of the factory wiring that stilll exists that you are asking about, if you pull the dash out a little bit on the driver side you will most likely see a plug for a factory switch underneath the headlight switch

It was pretty much right below where I put my switch here:

http://img.photobucket.com/albums/v5...0102081655.jpg

Ray_Welder 06-23-2008 11:18 AM

My dash actually has a hole where you put your switch at. I wish my vents still had the adjusters like yours, every vent in mine is broke except for the fake one.

Lone Ranger 93 06-23-2008 12:02 PM


Originally Posted by Ray_Welder (Post 989430)
My dash actually has a hole where you put your switch at. I wish my vents still had the adjusters like yours, every vent in mine is broke except for the fake one.

Must be a regular thing, the adjusters on both the passenger side vents were busted in mine, just snagged some out of an explorer at the junkyard and all better now


All times are GMT -6. The time now is 06:12 PM.


© 2024 MH Sub I, LLC dba Internet Brands