Ok so i bent my running board a couple months ago on a rock. well i finally got around to getting it off and i am trying to think of a way to bend it back, but nothings coming. Its not that bad, but it needs to be done. any ideas?

 

a torch and some muscle?

how bad is it bent?

 

factory running boards/step rails?? take 'em off and buy my extra set!

 

yeah factory. its not that bad. i might just leave it. i am going to try to put it in a pipe bender. i called ford and they want 300 for a set and 500 for just the passenger bar.....that makes sense

 

I just put jack stands underneath the brackets and took a bar and bent it back down. Done it 3 times now with no problems

 

how about using your truck to run over it

 

Seriously dude... buy some from Shane... I have a set of his in my garage and he has a set in his.... git-r-done!!

 

or just take those ugly ***** off and leave them off.

These are the only factory step bars I like. They're on my dad's '08 B4000.

 

the problem with taking them off and leaving them off is that instead of dealing with a bent running board i would be dealing with a dented up rocker panel.

 

Uh oh, better get Bondo!