bed bolts
#1
bed bolts
i am preping my truck to herculine it, and i am wondering about the bed bolts. i'm thinking that i want to take them out and tape off the holes in the bed. my question is, is it ok to use a pipe on my wrench on these guys? some of them are a real PITA to get out. also, is it safe to drive with some of the bolts out? i don't want to look in my rear view mirror and see my bed on the ground.
Last edited by ryan_88; 05-03-2008 at 09:51 AM.
#2
WOH WOH WOH....wait a minute. Use a T55 torx socket to remove the bed bolts. Use a breaker bar if you don't have an impact. Breaker bar meaning a piece of pipe slid onto your 1/2" ratchet....to provide more leverage.
And I would highly suggest having 4 bolts if you decide to drive it with some bolts. Definately the front two, and one set of the rear two.
And I would highly suggest having 4 bolts if you decide to drive it with some bolts. Definately the front two, and one set of the rear two.
#3
Use a T55 torx socket to remove the bed bolts. Use a breaker bar if you don't have an impact. Breaker bar meaning a piece of pipe slid onto your 1/2" ratchet....to provide more leverage
#5
#6
#8
#9
when mine was line-x'ed my step-dad worked for them so he did it and he pulled the truck in the booth and just took the bolts out there and sprayed it then put the bolts back in when he was done. i think he just stuffed something in the holes to keep the line-x out. but def. dont cover the bolts. had that on my 99' and after getting hit a couple times i started to come off. plus it just looked bad.
#10
Thread
Thread Starter
Forum
Replies
Last Post
rngprerunner
General Technical & Electrical
12
10-14-2019 11:05 AM
EdGe_wannabe
General Ford Ranger Discussion
3
05-09-2008 05:36 AM