Grille + Brush Guards for '97
#1
#2
#5
http://www.jcwhitney.com/autoparts/P...014007/c-10101 here it is. the only thing i did was upgrade the carriage bolt from the cheap one they sent to a grade 8 stainless. there also the square section on the inside of the carriage bolt was small compaired to hole in the guard that is why i upgraded to a little larger one that fits better. on the bottom 2, I cut the carriage bolts down because behind the bumper there isnt much room for the nut... just fyi
#6
#12
I ordered a new grille, the grille guard and 2 daylighters. I just got a big fat insurance check for the wind blowing a ladder over onto my truck... the insurance compant estimated almost 1000$ so i'm replacing the beat up grille and having the dent and scratch on my hood repaired for 370$
#14
double check but mine the square part on the back side was really small compaired to the slot in the gaurd if yours is the same i would head up to home depot and get some bigger stainless one's that fit better. if not then your fine.. the only thing when i bought the better one's the lower two i have to cut down on the new one's cause they where just a little to long for the area no big deal tho...
Thread
Thread Starter
Forum
Replies
Last Post
boyd_835
OLD - Interior, Exterior, Electrical, & Misc.
14
02-01-2013 10:17 PM
FMD
General Ford Ranger Discussion
32
04-12-2007 06:04 PM