Double Sided Tape
#1
Double Sided Tape
Hey guys.
I took the plastic side rails off my ford ranger to take out the bed liner, but have since changed my mind. So I would like to put them back on.
My problem is i can't get the double sided tape off the bed of the truck.
I have tried everything chemical wise I can find at my auto parts store.
goo gone, even a product called trim tape remover with no luck.
here is a pic of what I am talking about
I am open to anything,
Thanks
Emil
I took the plastic side rails off my ford ranger to take out the bed liner, but have since changed my mind. So I would like to put them back on.
My problem is i can't get the double sided tape off the bed of the truck.
I have tried everything chemical wise I can find at my auto parts store.
goo gone, even a product called trim tape remover with no luck.
here is a pic of what I am talking about
I am open to anything,
Thanks
Emil
#3
I use the 3m Eraser Wheels (sometimes called stripe off wheels)...they work great for removing vinyl stickers & pinstripes too. Basically no way to mess the paint up..it just eats up the foam or sticky surface. A little wax afterwards...and it's as good as new.
Item Detail
Item Detail
Last edited by logan03CO; 07-02-2010 at 08:49 AM.
#4
Member
iTrader: (2)
Join Date: Jan 2010
Location: SFL
Posts: 706
Likes: 0
Received 0 Likes
on
0 Posts
I use the 3m Eraser Wheels (sometimes called stripe off wheels)...they work great for removing vinyl stickers & pinstripes too. Basically no way to mess the paint up..it just eats up the foam or sticky surface. A little wax afterwards...and it's as good as new.
Item Detail
Item Detail
#5
I just used that eraser wheel attached to my drill. I ran it on low speed and it came right off.
I have one more question though. I have a tiny bit of residue left on the paint. Almost like a shadow of where the tape was. Since I'm just putting the rails back on do i have to take this off or should I be ok
Thanks for all your helps guys
Emil
I have one more question though. I have a tiny bit of residue left on the paint. Almost like a shadow of where the tape was. Since I'm just putting the rails back on do i have to take this off or should I be ok
Thanks for all your helps guys
Emil
Last edited by limE; 07-02-2010 at 12:01 PM.
#8
I had two strips about 3/8 wide going down both sides of the box, almost end to end.
Last edited by limE; 07-02-2010 at 01:21 PM.
Thread
Thread Starter
Forum
Replies
Last Post