Bumper/valance Repair
#1
Bumper/valance Repair
Alright, my Dad and I are going to try this by ourselves, I'm sure it'll turn out alright... But I need some tips on getting everytihing to run smooth.
The bumper has a ding (1/8" deep or so) and a nasty scratch that is down to the metal... I'm planning on filing the ding/scratch, but what do I fill it with?
The valance also has some nasty scrapes at the bottom of the valance... and it's covered in Duplicolor bed coating that is rubbing/chipping off in some spots... lasted 3-4 months...
I was thinking about bondo, but I don't think it's flexible enough... Or maybe some epoxy?
The bumper has a ding (1/8" deep or so) and a nasty scratch that is down to the metal... I'm planning on filing the ding/scratch, but what do I fill it with?
The valance also has some nasty scrapes at the bottom of the valance... and it's covered in Duplicolor bed coating that is rubbing/chipping off in some spots... lasted 3-4 months...
I was thinking about bondo, but I don't think it's flexible enough... Or maybe some epoxy?
Thread
Thread Starter
Forum
Replies
Last Post
sheen
OLD - Interior, Exterior, Electrical, & Misc.
11
12-08-2012 09:57 AM
Want to Buy: Ranger Front Valance or Bumper&Valance Painted
Ranger093
OLD - Interior, Exterior, Electrical, & Misc.
0
01-16-2010 12:28 PM