how many can fit?
#1
how many can fit?
ok i figure it would be cheaper to just put light tabs across the bumper instead of the light tabs with the angle iron or a light bar or brush guard cuz that kinda kills my pocket...
how many light tabs can i mount? im looking to mount 4 or 5 if its possible!!!
someone give me info!
how many light tabs can i mount? im looking to mount 4 or 5 if its possible!!!
someone give me info!
#2
#7
maybe a angle iron that has a very very short lip on it in the front with bolts grinded down a bit on the lights to give it a cleaner look would be fine... o well i guess itl be fine ill just fab it up how i want in the end lil dupli coor bed liner spray and were good to go lol thanks for the info everyone
#9
maybe a angle iron that has a very very short lip on it in the front with bolts grinded down a bit on the lights to give it a cleaner look would be fine... o well i guess itl be fine ill just fab it up how i want in the end lil dupli coor bed liner spray and were good to go lol thanks for the info everyone
#10
I made light tabs. There's only two bolts to bolt to. Current crossmember is approx 1.50x1". My new one is made out of 1/2 x 2" channel, with one of the sides chopped off, netting a 1/2 x 1.50" piece of angle iron. thicker and better looking imo than my current crossmember. (thanks again chad!)
My outside lights hold the crossmember to the tabs. You can make the crossmember wider, use seperate bolts to hold the xmember to the tabs, and probably fit 5 if you wanted.
Flat bar = non-rigid = bounce = crappy = you'll hate it. Also the lights are easily stealable if you used flat bar. angle iron is a PITA, at least mine is..lights all sucked into the grille and stuff.
Good luck...
My outside lights hold the crossmember to the tabs. You can make the crossmember wider, use seperate bolts to hold the xmember to the tabs, and probably fit 5 if you wanted.
Flat bar = non-rigid = bounce = crappy = you'll hate it. Also the lights are easily stealable if you used flat bar. angle iron is a PITA, at least mine is..lights all sucked into the grille and stuff.
Good luck...
#11
thanks for the opinions ima go with the angle iron cuz i sure would have to beat someone if i knew they took my lights as a matter of fact i put my initials on the inside of all 4 of my hella 500's when i put them together just incase thier was any thieve that tried to pawn them i could reclaim hahaha
#12
this a good set of lights to buy if i just want to step up a bit from the hella 500's but i want to keep the round lights and be able to still fit 2 larger lights on a bar kinda a setup like this oOOo ya know what i mean put 1 500 on left and 1 500 on the right and put the two 1000's in the middle..
hope im not confusing yall but back to my point are these good lights? cuz they have a very good price
http://www.adv4x4.com/he10drlakit.html
hope im not confusing yall but back to my point are these good lights? cuz they have a very good price
http://www.adv4x4.com/he10drlakit.html
#16
#17
#19
Thread
Thread Starter
Forum
Replies
Last Post
marc83
General Ford Ranger Discussion
13
12-04-2012 11:24 AM