Fiberglass fenders and 1piece front ends
 

Well, I wanted to wait to mod the body on my truck till after I did the SAS, but after hitting a deer, it is getting moved up the list.

I trashed the left front fender and the driver's door edge is rolled under. The valance might have just popped off, but not sure, still dark out. The brush gaurd is bent up, and worst of all, there is deer crap all down the side of my truck.

So my question is, is there a 1 piece fiberglass front end out there that isn't 10" wider on each side? Seems like everyone wants 10" wider on each side and that is waaay more than I will need. If I am gonna pay 300+ for fenders, I may as well try to find a 1 piece and be done with it. All I see are for older gens to look like our newer rigs.

http://www.mcneilracinginc.com/Frontends/Ford/Ranger/#

says it will fit 00 & 03, 6 inches wider.... and also lists a one piece here

http://www.mcneilracinginc.com/Ford/Ranger/01-03/#

also fiberwerx http://www.fiberwerx.com/ranger_conversions.htm

says they have a "93-02 to a 98-03 light 1-piece conversion" without any info though, its not a 150 conversion so its probably not as wide

Depending on my axle source, I may go with the 150 conversion if I get fullsize axles.

Hey guys thanks for the links to the conversion page. Ive been after a conversion for a while and never could find one.

soooo....sexy! droool. how would that look with 33"X12.5X15's? I would be all over that if it is an easy and reliable part.

Hmm, 700 aint bad at all! The hood I was looking at getting was almost 500 lol I am gonna give them a call on this! I know that Mcneil does some awesome desert stuff with the Ranger. The only one that I have seen 3 wheel without hydro's lol

If you got 5200 buck I know where a set of Portal axles from a Unimog with 1-7/8" axle shafts and Detroit Lockers are... they are nice and shiny black as well. You can also get the Stazworks Double Beadlocks and 40" Iroks, too.

Ummm, not really ready to go that extreme lol